In a condo or apartment tower, water and drain pipes run straight up and down through the building, stacked unit over unit. These vertical lines are called risers (supply) and stacks (drains). When one fails, the water doesn’t stay put. It follows the pipe and the wall cavity down, and it can show up in several units on several floors at once. In South Florida, where many towers along the coast and in Brickell, Downtown, Aventura and Fort Lauderdale are decades old, riser and stack leaks are some of the most common building water losses we see.
This is general information, not legal or insurance advice. Your condo documents, association counsel and insurers have the final say on responsibility and coverage.
Signs You May Have a Riser or Stack Leak
- Several units report water in the same spot, such as the same kitchen or bathroom wall, on different floors.
- A ceiling stain or drip with no unit directly above it leaking. The owner upstairs checks and finds nothing wrong in their unit.
- Water or staining that follows a vertical line along a wall, chase or pipe closet.
- Musty smells or bubbling paint on a shared wall in more than one unit.
- Drain backups or gurgling in several units on the same line, which can point to a drain stack problem.
What to Do First
Unit owners and renters
- Report it to building management or the front desk right away, in writing if you can.
- Take photos and video of every wet or stained area, with the date.
- Move belongings away from the wet area and stay clear of wet outlets and sagging ceilings.
- Owners: notify your own insurance company. Renters: tell your landlord in writing.
Boards, managers and building engineers
- Have the building engineer or a plumber isolate that riser or stack if water is still flowing.
- Check every unit on that line, above and below the reports, not just the ones that called. Water often reaches units that haven’t noticed yet.
- Notify owners on the line and keep a log of who reported what and when.
- Call your association’s insurance agent and your restoration company. The sooner drying starts, the less material has to come out.
Finding the Failed Section
The leak often isn’t where the water shows up. A plumber typically has to trace the line and may need to open walls or pipe chases in more than one unit to reach the failed section. In older buildings, original cast iron drain stacks and aging supply risers are frequent culprits, and one repair can turn up more worn pipe nearby. Moisture mapping helps narrow it down before anything is opened: we scan every affected unit with moisture meters and an infrared (thermal) camera to show where the water has spread.
Drying Every Unit on the Line
A riser leak is really several water losses at once. Each unit needs its own moisture readings, its own drying plan, and its own records, because each owner’s insurer and the association’s insurer may each be handling part of it. On a multi-unit job we:
- Map moisture unit by unit, including units below the visible damage
- Extract standing water and set commercial air movers and dehumidifiers
- Open only what has to be opened, and take daily readings until each area is dry
- Keep photos, moisture logs and reports organized by unit for the association, management and every insurer involved
- Work with residents’ schedules where we can, and coordinate access through management
Wet drywall and insulation can start growing mold within 24 to 48 hours in South Florida humidity, so fast drying matters. If mold has already started, we’re Florida-licensed mold remediators (MRSR4158).
Who Pays?
It depends on where the pipe failed (inside one unit’s walls or in a common element), your declaration, the association’s master policy and each owner’s policy. Clear documentation of the source and every affected unit makes that conversation much easier. More in condo leak from upstairs: who pays? and a condo board’s guide to water damage.
Get Ahead of the Next One
Know where every riser and stack shutoff is, who can approve emergency work after hours, and which restoration company to call. That’s what an Emergency Response Plan is for, and we’ll help you build one for free.
See how we handle burst pipe and building water damage in Miami-Dade, or commercial restoration across South Florida. We answer 24/7; when you call, we’ll tell you honestly when a crew can be there based on that day’s schedule. Hablamos español.
About the author: James Rice-Peña founded FL Cleanup, a family-owned South Florida restoration company serving homeowners and buildings since 2016. He has worked in restoration since 2012, is a Florida-licensed Mold Assessor (MRSA4035) and Mold Remediator (MRSR4158), IICRC certified, and FL Cleanup has 200+ five-star Google reviews and $1M in general liability coverage.



